0.05mm Configuration

General questions about the printer and printer software.

0.05mm Configuration

Postby newsgood » Thu Jul 02, 2015 3:30 am

Hello,

I hope to print at 0.05mm at Z, Height.

Any reliable configuration?

Thanks.
newsgood
 
Posts: 1
Joined: Thu Jul 02, 2015 3:28 am

Re: 0.05mm Configuration

Postby iboxpro » Fri Jul 03, 2015 9:55 am

Can you please send pictures of the printer number mentioned on the underside of the printer and the settings page.

- Ben
iboxpro
 
Posts: 3
Joined: Mon Jun 01, 2015 3:17 pm

Re: 0.05mm Configuration

Postby iboxsupport » Mon Jul 06, 2015 6:48 pm

For a 50micron print (aka 0.05mm) you will need a slightly shorter cure time. But more important you will need to set your Nano to 50 microns in SETTINGS and then also slice a model at 50microns in Slic3R, or download a 50 micron test print. To date the only 50micron test print in our BROWSE library is the ExoSkull14mm50micron, you can find test print images on this forum.

Let us know how it goes...
iboxsupport
Site Admin
 
Posts: 53
Joined: Mon Feb 16, 2015 2:16 pm


Return to General

Who is online

Users browsing this forum: No registered users and 1 guest

cron